Switchport Trunk Allowed Vlan Add. Switch Commands. ppt download c3550#configure terminal Enter configuration commands, one per line. It may appear odd that the allowed parameter is in the command but think of it like this, you are removing an allowed.
How to Configure VLAN on Cisco Switch Solutions from www.sysnettechsolutions.com
We can verify that using the show interfaces trunk command: This example shows how to remove VLANs 5 through 10 and 12
How to Configure VLAN on Cisco Switch Solutions
To add a VLAN to the trunk, issue the switchport trunk allowed vlan add vlan-list command To specify that only certain VLANs are allowed on the specified trunk, use the switchport trunk allowed vlan command. SW1#show interfaces trunk Port Mode Encapsulation Status Native vlan Fa0/1 on 802.1q trunking 1 Port Vlans allowed on trunk Fa0/1 1-1005 Port Vlans allowed and active in management domain Fa0/1 1,5,10 Port Vlans in spanning tree forwarding state and not pruned.
Allowed VLAN on Trunk Cisco Switch Hasil belajar Fikri. To add a VLAN to the trunk, issue the switchport trunk allowed vlan add vlan-list command Port Mode Encapsulation Status Native vlan Gi1/2/0/13 on 802.1q trunk-inbndl 1 (Po31) Port Vlans allowed on trunk Gi1/2/0/13 1-4093
Switchport Trunk Allowed Vlan All at Melissa Stayton blog. The confusion is about the appearance of what we see in running config In order to add a vlan I issued the 1st line command with the added vlan this erased the second line of the config on the port, why would this happen? The switch is a 4900M